The Saddle Sensor is a bespoke designed sensor to perfectly fit in between the Myford Super 7 Saddle and Apron, without any modification required.
The Cross Slide Sensor is designed to be bolted onto the saddle, with just 2 small M4 holes tapped in the saddle.
These holes are just 15mm deep, and can be achieved using a pillar drill or hand drill, as I've designed the sensor so the accuracy of these holes is not critical.
The compound slide sensor is designed to be installed a milled pocket inside the compound slide.
No separate milling machine required - this pocket can be milled using your Myford lathe and a vertical milling slide!
A brass cable guide attached to the apron keeps the wire routing neat, and the cable has a quick release connector to enable you to remove the compound slide whenever you like.
Terms and Conditions © All rights reserved